光学共振增强的表面铯激活银纳米结构光阴极

金属光阴极因其超短脉冲发射和运行寿命长的特性从而具有重要应用价值,但是较高的功函数和较强的电子散射使其需要采用高能量紫外光子激发且光电发射量子效率极低.本文利用Mie散射共振效应增强银纳米颗粒中的局域光学态密度,提升光吸收率和电子的输运效率,并利用激活层降低银的功函数,从而增强光阴极在可见光区的量子效率.采用时域有限差分方法分析银纳米球阵列的光学共振特性,采用磁控溅射和退火工艺在银/氧化锡铟复合衬底上制备银纳米球,紧接着在其表面沉积制备铯激活层,最后在高真空腔体中测试光电发射量子效率.实验结果表明平均粒径150 nm的银纳米球光阴极在425 nm波长的量子效率超过0.35%,为相同激活条件下银薄膜光阴极的12倍,峰值波长与理论计算的Mie共振波长相符合.     

Surface passivation in n-type silicon and its application in silicon drift detector

Based on the surface passivation of n-type silicon in a silicon drift detector(SDD), we propose a new passivation structure of SiO2/Al2O3/SiO2 passivation stacks. Since the SiO2 formed by the nitric-acid-oxidation-of-silicon(NAOS)method has good compactness and simple process, the first layer film is formed by the NAOS method. The Al2O3 film is also introduced into the passivation stacks owing to exceptional advantages such as good interface characteristic and simple process. In addition, for requirements of thickness and deposition temperature, the third layer of the SiO2 film is deposited by plasma enhanced chemical vapor deposition(PECVD). The deposition of the SiO2 film by PECVD is a low-temperature process and has a high deposition rate, which causes little damage to the device and makes the SiO2 film very suitable for serving as the third passivation layer. The passivation approach of stacks can saturate dangling bonds at the interface between stacks and the silicon substrate, and provide positive charge to optimize the field passivation of the n-type substrate.The passivation method ultimately achieves a good combination of chemical and field passivations. Experimental results show that with the passivation structure of SiO2/Al2O3/SiO2, the final minority carrier lifetime reaches 5223 μs at injection of 5×10¹⁵ cm^-3. When it is applied to the passivation of SDD, the leakage current is reduced to the order of nA.     

On-chip multiphoton Greenberger–Horne–Zeilinger state based on integrated frequency combs

One of the most important multipartite entangled states, Greenberger–Horne–Zeilinger state (GHZ), serves as a fundamental resource for quantum foundation test, quantum communication and quantum computation. To increase the number of entangled particles, significant experimental efforts should been invested due to the complexity of optical setup and the difficulty in maintaining the coherence condition for high-fidelity GHZ state. Here, we propose an ultra-integrated scalable on-chip GHZ state generation scheme based on frequency combs. By designing several microrings pumped by different lasers, multiple partially overlapped quantum frequency combs are generated to supply as the basis for on-chip polarization-encoded GHZ state with each qubit occupying a certain spectral mode. Both even and odd numbers of GHZ states can be engineered with constant small number of integrated components and easily scaled up on the same chip by only adjusting one of the pump wavelengths. In addition, we give the on-chip design of projection measurement for characterizing GHZ states and show the reconfigurability of the state. Our proposal is rather simple and feasible within the existing fabrication technologies and we believe it will boost the development of multiphoton technologies.     

Preparation and characterization of covalently bonded PVA/Laponite/HAPI nanocomposite multilayer freestanding films by layer‐by‐layer assembly

The layer‐by‐layer (LBL) assembly technique is an attractive method to make functional multilayer thin films and has been applied to fabricate a wide range of materials. LBL materials could improve optical transmittance and mechanical properties if the film components were covalently bonded. Covalently bonded nanocomposite multilayer films were prepared by employing hydrophilic aliphatic polyisocyanate (HAPI) as the reactive component, to react with Laponite and polyvinyl alcohol (PVA). FT‐IR spectra suggested that HAPI reacted with Laponite and PVA at ambient temperature rapidly. Ellipsometry measurement showed that the film thickness was in linear growth. The influences of HAPI on the optical, mechanical and thermal properties of the films were investigated by UV‐Vis spectroscopy, tensile stress measurement, DSC and TGA. The obtained results showed that the optical transmittance and mechanical strength were enhanced when the film components were covalently bonded by HAPI. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 545–551     

Protic Anions [H(B12X12)]− (X=F,Cl, Br,I) That Act as Brønsted Acids in the Gas Phase

The acidity of protic cations and neutral molecules has been studied extensively in the gas phase, and the gas‐phase acidity has been established previously as a very useful measure of the intrinsic acidity of neutral and cationic compounds. However, no data for any anionic acids were available prior to this study. The protic anions [H(B₁₂X₁₂)]^? (X=F, Cl, Br, I) are expected to be the most acidic anions known to date. Therefore, they were investigated in this study with respect to their ability to protonate neutral molecules in the gas phase by using a combination of mass spectrometry and quantum‐chemical calculations. For the first time it was shown that in the gas phase protic anions are also able to protonate neutral molecules and thus act as Brønsted acids. According to theoretical calculations, [H(B₁₂I₁₂)]^? is the most acidic gas‐phase anion, whereas in actual protonation experiments [H(B₁₂Cl₁₂)]^? is the most potent gas‐phase acidic anion for the protonation of neutral molecules. This discrepancy is explained by ion pairing and kinetic effects.     

Preparation of stereoscopic snowflake-like CoO material and its supercapacitor applications

Ionics - A novel stereoscopic snowflake-like CoO material is synthesized via a simple two-step process, including the hydrothermal process for the formation of the stereoscopic snowflake-like...